![]() |
|
Burris AR-332 Prism Sight |
Post Reply
|
Page <123> |
| Author | ||||||||
koshkin
Optics Jedi Knight
Dark Lord of Optics Joined: June/15/2004 Location: United States Online Status: Offline Posts: 5249 |
Quote Reply
Topic: Burris AR-332 Prism SightPosted: January/24/2009 at 23:00 |
|||||||
|
It can be seen if the power goes out.
I am not convinced that the holdover points make a whole lot sense here, as opposed to a simple circle/dot design. I would need to play with it a bit more say for sure (I have a DMS-1). When I looked at AR-332, I thought that the inside of the circle looked a bit too busy. While the holdover dots do not bother me, those lines (two horizontal and one vertical) inside the circle are, I think, strictly unnecessary. ILya |
||||||||
|
www.kitchentabletopics.com
Those who are merciful to the cruel, are cruel to the merciful. Talmud |
||||||||
![]() |
||||||||
Urimaginaryfrnd
Optics Jedi Knight
Resident Redneck Joined: June/20/2005 Location: Iowa Online Status: Offline Posts: 5879 |
Quote Reply
Posted: January/24/2009 at 23:30 |
|||||||
Boy that is right on the money I thought the reticle is unnecessarily busy. I really dont like the added lines to side and above if you have the circle and dots. I got a chance to look throught one of these today and I liked it. It is rather like an illuminated 4a
The mount did not seem sturdy enought for combat but for the average guy I think it would be just fine. The knobs look like exposed knobs but are in fact covers that unscrew. Over all I liked it thought. Edited by Urimaginaryfrnd - January/24/2009 at 23:39 |
||||||||
|
>>>=============>
OT's Least Politically Correct |
||||||||
![]() |
||||||||
Yak
Optics Apprentice
Joined: October/26/2008 Location: Michigan/Texas Online Status: Offline Posts: 67 |
Quote Reply
Posted: January/25/2009 at 02:46 |
|||||||
|
Does anyone have a line on the country Burris has tasked to manufacture and export the 332
(If its the PRC I'm not going to bite)? |
||||||||
![]() |
||||||||
Gang_Cop
Optics GrassHopper
Joined: May/01/2009 Online Status: Offline Posts: 1 |
Quote Reply
Posted: May/01/2009 at 20:32 |
|||||||
|
Hey is this only 3x or will it go from 1x to 3x??????
|
||||||||
![]() |
||||||||
helo18
Optics Master
Joined: December/02/2006 Location: Montana Online Status: Offline Posts: 2469 |
Quote Reply
Posted: May/01/2009 at 20:46 |
|||||||
That would be my only complaint so far with my illuminated Burris scope. Bad battery life. But if the reticle in the 332 is like my XTR you will still see it without illumination. As far as I know, that is the way it works with the 332. |
||||||||
|
Keep the big fan spinning! |
||||||||
![]() |
||||||||
Urimaginaryfrnd
Optics Jedi Knight
Resident Redneck Joined: June/20/2005 Location: Iowa Online Status: Offline Posts: 5879 |
Quote Reply
Posted: May/02/2009 at 00:26 |
|||||||
|
Fixed 3x if you need variable you might try this - I have one and it's not bad for the $ but larger and heavier than it looks.
|
||||||||
|
>>>=============>
OT's Least Politically Correct |
||||||||
![]() |
||||||||
TUFBOY
Optics GrassHopper
Joined: January/19/2009 Online Status: Offline Posts: 11 |
Quote Reply
Posted: September/14/2009 at 16:27 |
|||||||
|
I know after the last few months it may be hard to believe what Burris has said in regards to the release of their AR332 site, but I hold proof in my hand that the gentleman I spoke with is true to his word. This morning I received an AR332 at my front door directly from Burris. OK, I hear you now, getting it directly from Burris doesn’t mean they are shipping; I concur, but getting a new one in shrink wrap gives me a gut feel that they are in circulation and they will be in the hands of customer very soon, if not already.
My initial feelings are below. Plz keep in mind that they are based on having it for about an hour and not being able to fling lead with it on yet. 1. Good solid feel 2. Only a 1-year warranty concerns me. 3. The Ballistic CQ Reticle is nice, red & green illumination with 5 settings and a black non-powered reticle. 4. The Ballistic CQ Reticle is smaller than I expected, but very usable. 5. The holdoff dots are small; my older eyes can see them without too much trouble though. 6. The glass is clear, but a bit dark. The Burris Rep and I discussed this during our call and he advised me that this would be the case. It’s trade off for getting the unit at less than $300. I see no issue with saving a little $ for a bit darker site picture as it doesn’t appear to hamper the use of the site. 7. It’s about the same size as my EoTech 512 in a LT-110, but it’s not QR, which would be a good rev 2 upgrade… 8. While illuminated, the reticle has a shadow at 4:00 in low light situations while the brightness setting is on high (4 or 5). This goes away at lower brightness setting and in better light. This was tested in a dark basement, so YMMV. 9. While illuminated with the brightness level set at 5 in low light, you can see the rectangular film that the reticle is projected on. Not a big deal as in low light the brightness setting shouldn’t be on 5 anyways 10. You cannot use a BUIS with it, as you cannot see the front site clearly. It’s a 3x magnification, so that shouldn’t be expected anyway. My initial feeling on it is very positive. It has a nice feel and it seems to be well built and will withstand the abuse from the majority of shooters. For $300, it seems to be a great value and if it works as I hope, Burris may have a winner on their hands. Was it worth the wait, only time will tell, but based on my initial feelings, I think it was, but of course, I’ll reserve final judgment on that until I get a few hundred rounds through it. I hope to be able to get to the range this weekend and test it, if not, I’ll piss off my neighbors a bit and put a few rounds down range on my back yard 35-yard range and report back. I know, pics or it didn’t happen, see below, it really did happen. There are a few pics with the sunshade on and a few with it off…
|
||||||||
![]() |
||||||||
TUFBOY
Optics GrassHopper
Joined: January/19/2009 Online Status: Offline Posts: 11 |
Quote Reply
Posted: September/14/2009 at 16:29 |
|||||||
|
The above was posted on AR15.com by MidMicHunter late last week.
|
||||||||
![]() |
||||||||
danjojoUSMC
Optics Journeyman
Joined: August/20/2009 Location: San Diego, CA Online Status: Offline Posts: 314 |
Quote Reply
Posted: September/14/2009 at 22:14 |
|||||||
|
Thanks for sharing that, I'm thinking it will sell like crazy for Burris. Features+Not made in China+$300 price...
Soon there will be a lot of pics around the web with the 332 and FastFire's on top.
|
||||||||
![]() |
||||||||
mike8620
Optics GrassHopper
Joined: November/08/2007 Online Status: Offline Posts: 13 |
Quote Reply
Posted: September/15/2009 at 20:53 |
|||||||
|
I want one but i'm going to wait until ther's a good supply.
|
||||||||
![]() |
||||||||
TUFBOY
Optics GrassHopper
Joined: January/19/2009 Online Status: Offline Posts: 11 |
Quote Reply
Posted: September/16/2009 at 16:56 |
|||||||
|
Mike 8620, I wouldn't hold my breath on when they will be out. I've had one on order as of Jan. thru SWFA. I don't know MidMicHunter got one when SWFA can't even get a ship date from Burris. Burris won't even reply to any requested.
|
||||||||
![]() |
||||||||
TUFBOY
Optics GrassHopper
Joined: January/19/2009 Online Status: Offline Posts: 11 |
Quote Reply
Posted: September/16/2009 at 19:25 |
|||||||
|
From competitor today "Burris has decided to stop guessing at a release date and are now saying "We
don't know." Unfortunately, that's the most we can get out of them, and that's probably the most accurate statement they can make about it". Best regards, Ryan W, competitor, Inc. Product Specialist techsales@competitor.com US Toll-Free Phone: (800) 504-5897 Intl. Calls. (847) 513-6201 Fax: (847) 919-3003 http://www.competitor.com |
||||||||
![]() |
||||||||
Post Reply
|
Page <123> |
| Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |