Visit the SWFA.com site to check out our current specials. |
SS 10x42 question |
Post Reply |
Author | |
Urimaginaryfrnd
MODERATOR Resident Redneck Joined: June/20/2005 Location: Iowa Status: Offline Points: 14964 |
Post Options
Thanks(0)
Posted: January/14/2019 at 20:16 |
Lost me there. a 10x SS should zero at 200 with a 20 moa base with plenty of travel above and below. Do you mean how do you re set the knobs to Zero? if so you back out the three hex screws that secure the knob pull it straight up re align it press it down and tighten the three hex screws. Not sure I understand "shims in the elevation cap" there is no cap over the knob and a shim would go above or below the scope tube inside the rings on a scope with limited adjustment which this is not it should have plenty of adjustment if the rings and base are on correctly. If you are using the reticle for hold over first tell us if it is mil dot or mil quad. The turrets should be marked but the 10x has been made in several variations : https://www.swfa.com/swfa-ss-10x42m-tactical-30mm-riflescope-6.html MOA-Quad, 1/4 MOA Clicks, 15 MOA Revolution https://www.swfa.com/swfa-ss-10x42-tactical-30mm-riflescope-3.html Mil-Quad, 1/10 MIL Clicks, 5 MIL Revolution, Rear Focus The first ones were mil dots with 1/4 moa clicks https://www.samplelist.com/swfa-ss-10x42-riflescope-demo-c-3.html some have side focus most have rear focus then there is the 10HD Mil Mil To further complicate the answer Kenton Ind also engraves knobs for the SS. Edited by Urimaginaryfrnd - January/14/2019 at 20:21 |
|
"Always do the right thing, just because it is the right thing to do". Bobby Paul Doherty Texas Ranger |
|
3_tens
Optics Jedi Master Joined: January/08/2007 Location: Oklahoma Status: Offline Points: 7853 |
Post Options
Thanks(0)
|
Welcome back Billy. You have been gone way to long.
|
|
Folks ain't got a sense of humor no more. They don't laugh they just get sore.
Need to follow the rules. Just hard to determine which set of rules to follow Now the rules have changed again. |
|
cyborg
Optics God Gaseous Clay Joined: August/24/2007 Location: North Georgia Status: Offline Points: 12288 |
Post Options
Thanks(0)
|
Here ya go my man. http://swfa-ss.com/index.php/resources/brochures-manuals
|
|
With Freedom comes great responsibility, you cannot have one without the other
An armed public are citizens. A disarmed public are subjects. OATH KEEPER #8233 Support us, and join our cause. Cyborg |
|
WM5L
Optics GrassHopper Joined: January/12/2019 Location: SW Texas Status: Offline Points: 2 |
Post Options
Thanks(0)
|
Purchased a used SWFA SS 10X42 and have no paper work. Is there a Downloadable manual? One question I have right now is I'm sitting at 3 on the elevation with a 200 yd zero with a 20MOA rail no shims in the elevation cap. Is there any way to to get it to the first horizontal line instead of the third? and how many minutes of elevation and or windage do I get with one complete revolution of the elevation/ windage Turret?
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |